Spoiler Bumper

Introducing the Spoiler Bumper from Print For Speed – the next generation of 1:10 RC racing bumpers.

This revolutionary bumper design solves the common issue of air getting trapped under the body, which can negatively affect performance. The Spoiler Bumper acts as a built-in, hidden spoiler beneath the body, offering several advantages over traditional foam, honeycomb-structured, and other bumpers, such as:

• Increased front downforce.
• Improved steering response.
• Higher cornering speed.
• Maximum stability during high-speed maneuvers.
• Reduced tendency to roll over.

Wind tunnel tested and specifically designed for professional racers.

It is just as flexible as the original bumpers, and its weight depends on the chosen size (35-50mm), ranging from 9 to 14g.

Available in multiple sizes, compatible with various body shells and chassis types to ensure a perfect fit.

How to Measure the Perfect Size for You?

The bumper length, given in millimeters, is illustrated in the diagram below.

In words, the bumper length is the distance between the midpoint of the straight line connecting the center points of the body posts and the furthest point at the front of the bumper.

To determine the exact size you need:

STEP 1: Remove your current bumper and mount the body onto your car.

STEP 2: Mark the midpoint of the straight line connecting the center points of the body posts.

STEP 3: Measure the distance from this point to the inner wall of your body shell.

FINAL STEP: Subtract 1-2mm from the measured value, as the body shell should not rest directly on the bumper. Order the bumper in your calculated length by selecting the appropriate chassis and body type.

Finally, install your perfectly fitting bumper and hit the track!